Wall Surface Treatments

LB9* ACRYLIC MASONRY GLAZE & SEALER

 

Long term protection of roof and wall tiles, brickwork, all masonry, aluminium and metal surfaces where a long-lasting glaze is required. Seals exposed aggregate against staining, weathering and highlights natural texture and finish.

PRODUCT TO USE: LB9 ACRYLIC GLAZING LIQUID & SEALER

REQUIREMENT:
  1. Sealing & protection of concrete paving, car park areas, driveways etc. against dusting as well as resistance to penetration & staining by oil or grease, etc.
  2. Long-term protection and highlighting natural colour / appearance. of brickwork, pavers, roof and wall tiles, limestone or other masonry, aluminium or metalwork and where a long-lasting glaze is required
  3. Removal of efflorescence from paving, stairways, wall surfaces.
  4. To seal exposed aggregate / architectural masonry surfaces and highlight finish.

EFFECTS:


A clear glaze impregnation & surface sealer which dissolves most types of efflorescence and brings out the natural colour of masonry and tiles etc. LB9 is UV stable and resists penetration, staining and corrosion from oils, grease, juices, sugars etc. LB9 treated floors are easy to clean and require virtually no maintenance. Effective life, exterior vertical surfaces 12-15 years; Trafficable slabs 5 – 8 years or more, depending on traffic.


NOTE:


1) LB9 is an acrylic resin in a penetrating solvent and does NOT contain silicone.

2) LB9 is UV stable, making it suitable to outdoor use. For sealing interior / covered trafficable slab areas, Cementaid ROKITE is recommended to be used.

3) Surfaces subject to excessive rising damp may cause discolouration/damage – if in doubt conduct suitable trial area first.

WHERE RECOMMENDED:


External concrete floors / car park areas etc, driveways and pavers, roof and wall tiles exposed aggregate, brickwork, limestone, school and kindergarten walls, where long lasting glaze and surface sealed protection is required.


PRECAUTIONS:


LB9 is solvent-based. Observe all usual precautions with solvents. Use only under well ventilated conditions. NO SMOKING. NO NAKED FLAMES. Do not use in areas where solvent odours may enter building ventilation air intakes or adjacent structures, or affect stored foodstuffs or other materials.

SPECIFICATIONS

All surfaces to be thoroughly clean & dry, free of oil, grease or other contaminants. Brush down to remove all loose foreign material. Then apply one or two coats of CEMENTAID LB9 Glazing Liquid (allow 4-6 hours between coats).
Apply at the rate of 4-5m 2 per litre, depending on porosity. Coverage for 2 nd coat if required, at rate of 6 – 8m 2 per litre. LB9 is best applied by brush or low-pressure knapsack spray. Equipment should be cleaned with solvent based thinners such as Xylol (available from Cementaid).

INDUSTRIAL FLOOR SPECIFICATIONS - GEL CONTROL AGENT - ANTI-CORROSION IMPREGNATIONS - OIL & SOLVENT PROOFING - WATERPROOFING - RAPID HARDENING RETARDING - SURFACE TOUGHENING - MORTAR AND DAMPCOURSE ADMIXTURES, ETC.

The information and recommendations herein are, as a result of experience and testing, accurate to the best of the seller’s knowledge. However, as the proposed use and the circumstances surrounding such use are not known to the seller, it does not guarantee or warrant the product’s suitability in any particular instance and shall not be liable for any loss or damage consequent upon any use whatsoever unless the seller has otherwise stipulated the product’s suitability for a particular use in writing signed by a Director of the seller..




       

Link to Spec-Net Construction & Engineering Gateway