CALRES 120
The protection of industrial concrete floors where
the prevention of dusting, sealing against occasional oil and grease spillages, and an easily cleaned surface is
required.
Recommended for light industrial use in low traffic areas.
EFFECTS: |
A clear semi-glaze impregnation which dissolves most types of efflorescence and enhances the natural colour of the concrete. Dust proofs the floor and seals the surface against staining from mild spillages. For heavy duty or high wear, exterior applications, or for coloured applications,we recommend you specify and use CEMENTAID LB9, or CEMENTAID ROKITE. |
NOTE: |
CEMENTAID "CALRES 120" is an acrylic resin in a penetrating solvent, and does NOT contain any silicone resins. |
WHERE RECOMMENDED: |
All concrete surfaces subject to dusting, where light industrial traffic or wear, or where occasional oil and grease spills are expected. |
FOR APPLICATION SERVICE: |
Contact your local CEMENTAID representative. |
|
SPECIFICATIONS |
| All surfaces to be thoroughly dry and free of all oil or grease. Brush down to remove all surface dust and loose
matter. Apply one or two coats of CEMENTAID "CALRES 120", depending on the porosity of the floor,
at the rate of 4-5m2/l. CEMENTAID "CALRES 120" is best applied by brush, roller or knapsack spray. Equipment should be cleaned with solvent based thinners such as Xylol. |
|
INDUSTRIAL FLOOR SPECIFICATIONS - GEL CONTROL AGENT - ANTI-CORROSION IMPREGNATIONS - OIL & SOLVENT PROOFING - WATERPROOFING - RAPID HARDENING RETARDING - SURFACE TOUGHENING - MORTAR AND DAMPCOURSE ADMIXTURES, ETC. |
| The information and recommendations herein are, as a result of experience and testing, accurate to the best of the seller's knowledge. However, as the proposed use and the circumstances surrounding such use are not known to the seller, it does not guarantee or warrant the product's suitability in any particular instance and shall not be liable for any loss or damage consequent upon any use whatsoever unless the seller has otherwise stipulated the product's suitability for a particular use in writing signed by a Director of the seller. |
