 |
|
|
SPECIFICATION FOR |
CALBOND* |
REQUIREMENT: |
Bonding to brick, concrete or masonry, without roughening or hacking. |
PRODUCT TO USE: |
CALBOND* (Double Strength Bonding Agent) |
HOW TO SPECIFY: |
All surfaces (state areas) shall be clean, pre-dampened and prepared for plastering /
rendering / bonding by application of a liberal coat of Cementaid CALBOND, which shall be
allowed to dry to a “tacky” condition (10-20 mins.) before applying render or plaster.. Consult
manufacturer for details of surface cleaning, etc. |
EFFECTS: |
CALBOND forms a plastic “key” into the surface pores of the base masonry, which when not
fully dry will partially re—dissolve in the damp render pr plaster. When set and dried, the
whole sets into a hard, tough unit strongly assisting firm adhesion of the surface render. Fully
compatible with all Cementaid products. |
WHERE
RECOMMENDED: |
Rendering onto non-roughened surfaces, including integrally waterproofed concrete. Repair of
cracks and faults in masonry. As an admixture in mortar or concrete mix, where elasticity and toughness are required. For new Floor Toppings: A slurry of CABOND and cement mixed in the proportions o 2 parts CALBOND, 2 parts cement and 1 part water, when applied liberally on a clean surface will assist adhesion of applied toppings. All toppings must be well cured, using either water and/or suitable CALCURE Curing Membrane (See Cementaid CALCURE Data Sheets for further information re curing). NOTE: For substrates / sections exposed to prolonged damp or wet conditions, or external applications, Cementaid WELDCRETE Water-Resisting Bonding Agent & Latex Modifier is recommended to be used in place of CALBOND |
PACKAGING: |
205 Litre, 20 Litre, 5 Litre, 1 Litre |
