Form Oils, Curing & Bonding Agents

CALCURE C30

High Efficiency Concrete Curing - Single spray application, without
external covering or continuous water spray/ponding


EFFECTS:

Calcure C30 is an economical, sprayable, wax based curing compound which seals the surface of fresh concrete, reducing moisture loss and providing high efficiency curing.
Calcure CR complies with AS 3799 and RTA 3202.

WHERE RECOMMENDED:

All concrete surfaces which require high efficiency curing, and areas to which standard curing methods would be difficult or uneconomical. Calcure C30 may also be used as a de-bonding agent. When used for this purpose, a trial area is always recommended to be done to confirm satsifactory performance.

Note: If materials are to be bonded to surfaces to which Calcure C30 has been applied, sandblasting or solvent treatment is recommended before bonding is attempted.

CONTACT CEMENTAID FOR APPLICATION SERVICE

CAUTION:

Calcure C30 is best stored out of direct sunlight, and has a shelf life of 3 months maximum. Do not specify Calcure 30 or any other curing compounds where liquid surface hardeners such as CEMENTAID DIAMITE are specified to be used, as penetration of these treatments would be impaired. In such cases, specify water, damp sand or plastic sheet curing.

For application, "Rega" or equivalent pneumatic knapsack spray is recommended with No. 9, 10 or 11 fantail nozzles. Equipment should be cleaned by flushing thoroughly with cold water.

SPECIFICATIONS

All concrete shall be cured by a liberal application kof Cementaid Calcure C30 sprayed on to the surface as soon as possible after finishing or removal of forms, at a rate of 5 square metres per litre.

INDUSTRIAL FLOOR SPECIFICATIONS - GEL CONTROL AGENT - ANTI-CORROSION IMPREGNATIONS - OIL & SOLVENT PROOFING - WATERPROOFING - RAPID HARDENING RETARDING - SURFACE TOUGHENING - MORTAR AND DAMPCOURSE ADMIXTURES, ETC.

The information and recommendations herein are, as a result of experience and testing, accurate to the best of the seller's knowledge. However, as the proposed use and the circumstances surrounding such use are not known to the seller, it does not guarantee or warrant the product's suitability in any particular instance and shall not be liable for any loss or damage consequent upon any use whatsoever unless the seller has otherwise stipulated the product's suitability for a particular use in writing signed by a Director of the seller.




       


Link to Spec-Net Construction & Engineering Gateway